You shouldbe reported to Steve for lack of 02 content in that post 🙂

There is roof...

I've never seen that much square tube in or near a car before. Is that a support structure for the cage while under construction? Crane fixture to hold the car off the ground? Rotisserie? 

Yeah it’s support for 02 shell. Crane towers on both ends are for lowering & raising shell over jig table/E85 floor until shell is worked to sit flush on E85 bottom half AND when roll cage is welded enough. Can’t get torch every place if i mate them now.

Yeah it’s support for 02 shell. Crane towers on both ends are for lowering & raising shell over jig table/E85 floor until shell is worked to sit flush on E85 bottom half AND when roll cage is welded enough. Can’t get torch every place if i mate them now.