Removing tar board, fixing window corners, and rear panel
When I haven't posted an update for a while, it means I haven't done anything, usually. I've actually been getting a lot done on this. Where to start?
My rear window bottom corners were replaced at some point, and poorly. I was able to source donors an put those in. Very happy.
The back panel had about 1/2" of filler in spots. I ground all that out and did some fine tuning on it, and it's much better now. It isn't perfect, but it doesn't have to be. That will get replaced years down the road when I replace the front.
And finally, I removed the tarboards from the interior. 3M adhesive remover worked really well. This still took a lot of time and I'm only half way done!
- 1
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now