Door Window Parts Question?

[RMBaiada]

I have just installed my roll up door window, but not sure where the part below goes. I believe that it is part #13 in the exploded view, but I can't see where it goes. Also, I don't have parts #11, 12, 18 or 19. Do I need those? What is there function?

 

Any help is appreciated.

 

 

Edited February 7, 2021 by RMBaiada

[tzei]

In photo is #11 stopper and #12 is its counter part. Window & rubber thingie gets sandwiched between those. # 18 & 19 is same thing (front stopper).  Yes you’ll need those to limit window at its upmost position. Never seen #13.

[02Les]

#13 is for the '02 Cabriolet only, and as stated above, you need the other parts.

[RMBaiada]

Does anyone have pictures of the stoppers (11, 12, 18 and 19) installed?

 

Thank you,

Michael

[RMBaiada]

From this discussion, I was able to figure out where parts #11, 12 and 19 fit. 

 

It seems like parts #18 and 19 are either or, as they both seem that they would provide the same function. Is this the case? 

 

My windows stop correctly at the top of the travel with parts #11 and 19, but I am missing one each of part #12 (plate) and 19 (stopper) for the driver's door.

 

Thank you,

Michael

[duckdudess]

My driver's door card was off, so I took a few photos:  one of the front stop, one of the rear stop and one of the upper door tabs that stop those stops.

[RMBaiada]

Perfect. Thank you.

 

It looks like on my car uses part #11, 12 and 19. Part #18 must go to the Cabriolet with part #13.

 

Michael