Trunk floor replacement panel

[EricA]

It seems like a lot of these cars have had damage to the rear panel over the years.  They're relatively flimsy.  Mine was poorly repaired with lots of body filler, so it seemed to make sense to change it at the same time as the floor.  My floor had some rust and was slightly wrinkled from the past rear end damage.  I did find a NOS BMW taillight panel for my car, so can't comment on the MVP taillight panel.  I think pulling the taillight panel off the car helped when trying to fit the truck floor.  It's a tight fit!  Good luck with your project!

[Scittbox]

Looks like kooglewerks makes one for square lights 

 

BMW 2002/1600 Late Model Tail Panel (Square Tail Lights) 74-76 — kooglewerks

WWW.KOOGLEWERKS.COM

---

BMW 2002/1600 Late model EURO tail panel replacement sheet metal. An accurate reproduction, this repair...

 

 

lots to consider here

[Mikesmalaga72]

You may want to check the location of the gas tank bolt holes with your current tank to see if they line up...there were remedies posted here in the past.

[popovm]

On 7/12/2023 at 3:31 PM, Scittbox said:

Looks like kooglewerks makes one for square lights 

 

BMW 2002/1600 Late Model Tail Panel (Square Tail Lights) 74-76 — kooglewerks

WWW.KOOGLEWERKS.COM

---

BMW 2002/1600 Late model EURO tail panel replacement sheet metal. An accurate reproduction, this repair...

 

 

lots to consider here

 I am sure that's an MVP manufactured piece.