spacers

[jrkoupe]

beautiful pieces.

When you say expensive..........how much would someone have to pay your friend to make another set?.....

My bad...this wasnt meant to be a new post...just a reply to another.....

[alp]

you mention that you were going to buy a set of rear flairs for your project. Who are they from and any contact info? I can see if a buddy of mine would make a run of these with his CNC mill if there is some interest.

[alp]

they are already here.... http://massivebrakes.com/home/ and cheap!

[bmw1602.com]

they are already here.... http://massivebrakes.com/home/ and cheap!

but lee doesn't make the offset spacers....he said he would but he said there wasn't enough demand

[alp]

I didn't look to see that there was a difference. I will look at them again.

[bmw1602.com]

the ones he made are offset like the ones you can get from germany..... since he was so kind to share the blue prints I'm going to create them in Solidworks and have a run made........maybe .......lets see!

[alp]

so the offset amount is the difference you see in the bolt holes?

[allbim]

so the offset amount is the difference you see in the bolt holes?

Yes it is (15mm or .590"), on the ones I make.

This makes about a 1.25 degree difference.