Son of Marty
-
Posts
6,722 -
Joined
-
Last visited
-
Days Won
79 -
Feedback
0%
Community Answers
-
Son of Marty's post in 5 Speed conversion question... was marked as the answer
Clutch and flywheel will work you'll need the e21 slave clutch arm and throw out bearing.
-
Son of Marty's post in What is the purpose of this spring was marked as the answer
It's needed to ground the horn circuit. ether style will do the job.
-
Son of Marty's post in Getrag 245 gearbox verification was marked as the answer
2nd that I have no idea what that trans fits.
-
Son of Marty's post in What is this? And can I remove it? was marked as the answer
It's the left side engine mount if it's not connected to the engine then your missing part 13 in the drawing above. Disregaurd the round mount in the picture it's the old style the new style looks like this which bares a close resemblance to the part in your picture..
-
Son of Marty's post in Hand brake light switch photos? was marked as the answer
Brake pressure differential switch, the reset button should be between the 2 wires afaik.
-
Son of Marty's post in Air filter housing to body bolt was marked as the answer
Yes 6x10 and 10mm long full thread with a wave washer and your good to go
-
Son of Marty's post in Starting/Electrical Power issue was marked as the answer
There should be a 2nd smaller positive connection that connects to the large positive battery clamp make sure it's clean and tight there is also a small ground wire from the neg terminal to the body to check.
